Power Calculation Algorithm for Single-Phase Droop-Operated Inverters Considering Nonlinear Loads and unsing n-Order SOGI Filtering J. El Mariachet, J. Matas, J. de la Hoz, Y. Al-Turki, H. Abdalgader 2018/04/20

Abstract

The average active and reactive powers, P and Q, are crucial parameters that have to be calculated when sharing common loads between parallelized droop-operated single-phase inverters. However, the droop method algorithm should employ low-pass filters (LPF) with very low cut-off frequency to minimize the distortion impact in the provide droop amplitude and frequency references. This situation forces the droop control to operate at a very low dynamic velocity, degrading the stability of the parallelized system. For this reason, different solutions had been proposed in literature to increase the droop velocity, but the issues derived from the sharing of nonlinear loads had not been properly considered. This work proposes a novel method to calculate P and Q based on the fundamental components of the inverter's output voltage and current and using the measured phase angle between the output voltage and current. The method is used under normal and highly distorting conditions due to the sharing non-linear loads. The fundamental components are obtained by means of the highly filtering capability provided by n-order cascaded second order generalized integrators (nSOGI). The proposed method leads to faster and more accurate P and Q calculations that enhances the droop-method dynamic performance. Simulations are provided to validate the proposal.

Authors and affiliations

J. El Mariachet†, J. Matas†, J. de la Hoz†, Y. Al-Turki*, H. Abdalgader*
† Department of Electric Engineering, Universidad Politécnica de Cataluña (UPC), Barcelona, Spain.
*Renewable Energy Research group, King Abdulaziz University (KAU), Jeddah, Saudi Arabia.

Key words

Active and reactive power calculation, singlephase inverters, nonlinear loads, inverter parallelization, droop method, harmonic distortion, power quality.

References

[1] E. A. A. Coelho, P. C. Cortizo and P. F. D. Garcia, "Small signal stability for single phase inverter connected to stiff AC system," Conf. Record of the 1999 IEEE Industry Applications Conf. 32th IAS Annual Meeting (Cat. No.99CH36370), pp. 2180-2187 vol.4, 1999.
[2] M. Soshinskaya, W. H. J. Graus, J. M. Guerrero, J. C. Vasquez, "Microgrids: experiences barriers and success factors", Renew. Sustain. Energy Rev., vol. 40, pp. 659-672, 2014.
[3] L. S. Araújo, D. I. Narváez, T. G. Siqueira and M. G. Villalva, "Modified droop control for low voltage single phase isolated microgrids," 2016 IEEE Int. Conf. on Automatica (ICA-ACCA), pp. 1-6, 2016.
[4] "IEEE Standard definitions for the measurement of electric power quantities under sinusoidal, nonsinusoidal, balanced or unbalanced conditions, IEEE Standard 1459-2010", Mar. 2010.
[5] J. Lu, Y. Wen, Yingchao Zhang and W. Wen, "A novel power calculation method based on second order general integrator," 2016 IEEE 8th Int. Power Electronics and Motion Control Conf. (IPEMC-ECCE Asia), Hefei, pp. 1975-1979, 2016.
[6] E. T. Andrade, P. E. M. J. Ribeiro, J. O. P. Pinto, C. L. Chen, J. S. Lai and N. Kees, "A novel power calculation method for droop-control microgrid systems," 2012 27th Annual IEEE Applied Power Electronics Conf. and Exp., (APEC), pp. 2254-2258., 2012.
[7] Z. Ren, M. Gao, Q. Mo, K. Liu, W. Yao, M. Chen and Z. Qian "Power Calculation Method Used in Wireless Parallel Inverters Under Nonlinear Load Conditions," in Proc. of APEC, pp. 1674-1677, 2010.
[8] E.C. Furtado, L.A. Aguirre and L.A.B. Torres, "UPS Parallel Balanced Operation Without Explicit Estimation of Reactive Power - A Simpler Scheme," IEEE Trans. on Circuits and Systems II: Express Briefs, vol.55, no.10, pp. 1061-1065, Oct. 2008.
[9] J.M. Guerrero, J. Matas, L. G. Vicuna; M. Castilla and J. Miret, "Decentralized Control for Parallel Operation of Distributed Generation Inverters Using Resistive Output Impedance," IEEE Trans. on Industrial Electronics, vol.54, no.2, pp. 994-1004, Apr. 2007.
[10] S. A. O. Silva, R. Novochadlo and R.A. Modesto, “Single-phase PLL structure using modified p-q theory for utility connected systems,” in Proc. of IEEE PESC, pp. 4706-4711, 2008.
[11] H. Wang, X. Yue, X. Pei and Y. Kang, “A new method of power calculation based on parallel inverters,” in Proc. of IEEE EPE-PEMC, pp. 1573-1576, 2009.
[12] Yu, D. Xu and K. Ma, “A Novel Accurate Active and Reactive Power Calculation Method for Paralleled UPS System,” in Proc. of APEC, pp. 1269–1275, 2009.
[13] Zheng Ren; Mingzhi Gao; Qiong Mo; Kun Liu; Wei Yao; Min Chen; Zhaomin Qian, "Power calculation method used in wireless parallel inverters under nonlinear load conditions," Applied Power Electronics Conf. and Exp., 2010 25th Annual IEEE, pp.1674,1677, 21-25 Feb. 2010.
[14] Wei Yu; Dehong Xu; Kuian Ma, "A Novel Accurate Active and Reactive Power Calculation Method for Paralleled UPS System," Applied Power Electronics Conf. and Exp., 2009. (APEC 2009). 24th Annual IEEE, pp.1269,1275, 15-19 Feb. 2009
[15] H. Akagi, E.H. Watanabe, M. Aredes, "Instantaneous Power Theory and Application to Power Conditioning," Piscataway, NJ: John Wiley & Sons, Inc., 2007, pp. 5-28
[16] Mingzhi Gao; Shangda Yang; Cheng Jin; Zheng Ren; Min Chen; Zhaoming Qian, "Analysis and experimental validation for power calculation based on p-q theory in single-phase wireless-parallel inverters,"Applied Power Electronics Conference and Exposition (APEC), 2011 26th Annual IEEE, pp.620,624, 6-11 March 2011
[17] J. Matas, M. Castilla, L. G. d. Vicuña, J. Miret and J. C. Vasquez, "Virtual Impedance Loop for Droop-Controlled Single-Phase Parallel Inverters Using a Second-Order General-Integrator Scheme," in IEEE Trans. on Power Electronics, vol. 25, no. 12, pp. 2993-3002, Dec. 2010.
[18] S. Tolani and P. Sensarma, "An improved droop controller for parallel operation of single-phase inverters using R-C output impedance," 2012 IEEE Int. Conf. on Power Electronics, Drives and Energy Systems (PEDES), Bengaluru, 2012, pp. 1-6.
[19] Y. Yang, F. Blaabjerg and H. Wang, "Low voltage ride-through of single-phase transformerless photovoltaic inverters," 2013 IEEE Energy Conversion Congress and Exposition, Denver, CO, 2013, pp. 4762-4769.
[20] Y. Yang and F. Blaabjerg, "A new power calculation method for single-phase grid-connected systems," 2013 IEEE International Symposium on Industrial Electronics, Taipei, Taiwan, 2013, pp. 1-6.
[21] J. M. Guerrero, N. Berbel, J. Matas, L. G. de Vicuna and J. Miret, "Decentralized Control for Parallel Operation of Distributed Generation Inverters in Microgrids Using Resistive Output Impedance," IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics, Paris, 2006, pp. 5149-5154.
[22] H. Song and K. Nam, “Dual current control scheme for PWM converter under unbalanced input voltage conditions,” IEEE Trans. Ind. Electron., vol. 46, no. 5, pp. 953-959, Oct. 1991.
[23] IEEE Standard Definitions for the Measurement of Electric Power Quantities Under Sinusoidal, Nonsinusoidal, Balanced, or Unbalanced Conditions - Redline," in IEEE Std 1459-2010 (Revision of IEEE Std 1459-2000) - Redline , vol., no., pp.1-52, March 19 2010
[24] J. M. Correa, F. A. Farret and M. G. Simoes, "Application of a Modified Single-Phase P-Q Theory in the Control of Shunt and Series Active Filters in a 400 Hz Microgrid," 2005 IEEE 36th Power Electronics Specialists Conference, Recife, 2005, pp. 2585-2591).
[25] J. Matas, M. Castilla, J. Miret, L. G. Vicuna, and R. Guzman, “An adaptive prefiltering method to improve the speed/accuracy tradeoff of voltage sequence detection methods under adverse grid conditions,” IEEE Trans. Ind. Electron., vol. 61, no. 5, pp. 2139–2151, May 2014.
[26] G. M. S. Azevedo, M. C. Cavalcanti, F. Bradaschia, F. A. S. Neves, J. Rocabert and P. Rodriguez, "Enhanced power calculator for droop control in single-phase systems," 2011 IEEE Energy Conversion Congress and Exposition, Phoenix, AZ, 2011, pp. 391-396